Log In    |    Register
Home / News > Recording studio recording skills: better recording position and microphone placed


Recording studio recording skills: better recording position and microphone placed

Live recording of the two cases: one for the recording studio live recording; two live recording for the show. This article mainly stresses recording studio. Recorded in a professional recording studio, because all the conditions are in the careful planning and control under, so easy to control the scene, the recording will be more smoothly. At this time as long as the attention of the various parts of the microphone array and the crosstalk of each other can use the multi-channel recording method for recording. Recording the room itself will have a great impact on the sound, so to find a better position to play the sound is very important, then how can more easily find a better recording position? When you record a band, especially the melody part, recording better position and lack of sound quality and musicians compared to the problem is not so important. But when you record a song or a soundtrack, or when you record a single instrument alone, it is the most important question to choose a better position for recording. You need to find a place in your studio or studio that has a relatively minimal impact on the environment.

We can find the best location according to the following steps:

First, in the studio inside clapping edge, this is a reverb to find the weakest area of ??the good way, because the clapping is a short vibration of the sound, easy to hear the sound of reflection. If you can not find a place without reverb, find a relative reverb the smallest place.

Second, put some filler on the side wall or other soft material, especially in the corner, the corner is usually the most low frequency standing wave, which means that the low frequency is strengthened. When you are recording, this may cause resonance like a buzzing buzzing.

Third, under normal circumstances not too close to the wall, from the wall too close, whether it is reflective or soft material sound absorption, will change the sound of the instrument, especially in the use of all pointing to the microphone recording a large drum and percussion instruments, The middle of the room is usually a better choice.

Fourth, the ideal situation is better beats by dre cheap not to choose in the roof of the higher position of the recording, you can first place the center of the roof position, and then move slowly as needed to find a better location.

5, if the studio is not completely closed, be sure to stay away from the glass as much as possible, the glass will produce a lot of reflection, thus changing the sound. As the room decoration problems so that your position can not avoid the glass, the glass and the instrument was placed at an angle of 45 .

Six, put a piece of carpet under the recording singer or musician, can prevent reflection from the ground, because this reflection will have a negative impact on the overall voice.

7, sometimes, the ground reflection will enhance the sound, when you need this effect, you can remove the carpet, so your studio should be prepared carpet, shop can shop can try.

8, the studio guitar or bass speakers better placed in a chair or box, conditional, such as can be placed in the sound pad (Acoustic Foam) on the better. This way, when the speaker away from the ground, can effectively prevent low frequency and phase offset, the sound beats earbuds will be more direct and clear.

Finding the studio's better recording position is a critical step in recording when it takes away from the room's harmful reflections, corners, walls and glass. Finally, according to the final needs, in the recording location covered with carpet to prevent the ground reflection.

If you want to record a smooth and smooth sound, let's take a look at a few things you need to do before recording a microphone.

First, the world does not exist multi-capable microphone, not because you have a high quality and expensive microphone can cover any situation of the recording, according to the correct use of occasions to determine the use of what kind of microphone.

Second, not because a microphone is the industry standard, it means that it must be applied to any special occasions under the recording, the same, not because of the recording singer, musicians like to use what kind of microphone, you can choose He used it. Because you are a sound engineer, only your ears is right.

Third, choose a microphone for your recording icing on the cake, is the most important.

Fourth, to choose a different microphone to overcome some of the lack of sound of the instrument, if the recording sound is too sharp, that is, too much high frequency, do not choose a high-frequency range of the microphone, because the high frequency too much frequency It is not balanced. Too much high frequency will make rounded sound from the mix out.

Fifth, consider the PickupPattern (PickupPattern), that is, directivity, non-full point of the microphone is not a better choice, when adding a new recording or stack and do not consider the case of sound leakage, the full point and double point ( 8 font) in a good recording environment will make the sound more stable.

Six, taking into account the proximity of the proximity of the distance and the non-full-pointing microphone, may cause the sound to be too low, which is usually not the sound we want. So, please go away from the sound source or replace the full point of the microphone, on the contrary, in the low frequency can also use the proximity effect to increase the low frequency you need.

Seven, not in any case, the large diaphragm condenser microphone is better than the small diaphragm condenser microphone. In fact, many small diaphragm condenser microphone low frequency response is also very good, and not easy to lead to the sound of the color too heavy. But usually large diaphragm condenser microphone noise reduction capability to be better.

8, select the microphone to be based on the sound of the sound source to decide, do not have to be afraid of your choice of the microphone is in line with industry standards, as long as to ensure that master the effect of proximity.

Nine, and finally to try a different point of view, to find the sound to be recorded that the most favorable one.

Five tips for the microphone

First, when you start to add more than one microphone, and use the compressed and EQ happy to find the better sound recording, you will find it very easy to disappoint. This is because you are likely to ignore the importance of the placement of the microphone.

When you go to the studio, standing next to the instrument, it is important to listen carefully to the part of the music you want to record, because you may be blinded by random play. Listen to the real sound of the human voice or the instrument, and listen to the performance of these sounds in the current space.

The sound you have just heard can be used as a reference in your control room, and the sound of the control room is compared with the sound you just heard and will play a critical role in your recording.

Second, find a better way to position the microphone:

1, place a full-pointing microphone, cover an ear, listen with another ear, you can turn around the musician, until you find a sound that sounds better point, this is where the microphone is placed.

2, place a heart-shaped point of the microphone, cover your ears, hold up with your hand, listen with another ear, you can turn around the musicians or musical instruments, until you find a sound sounds better point, Place the microphone first here and then fine tune it.

3, place a stereo microphone or stereo dual microphone, hands up two ears to surround the musicians or musical instruments to turn, until you find a better beats headphones cheap position, first placed the microphone here, and then to fine-tune.

Third, can not rely on to see the microphone can determine the better position, can not just infer, listen to the initial position, not necessarily the final good position.

Fourth, improve the sound depends on the location of the microphone rather than by the late EQ or compression and other dynamic processing. In fact, you can completely move the microphone to improve the sound quality without having to use EQ, once again reiterated; pre-recording use of the EQ in the latter can not be removed, if your recording experience is insufficient, this operation is easy to leave can not be removed unnatural feel.

5, move the microphone, carefully looking for the right location, the sound will sound very comfortable, if possible to the microphone and the sound source out between the enough distance, so that the sound with a little room reflection. Give the microphone some distance, because the right distance can create a better sound. The distance between the appropriate microphone and the instrument and the instrument speaker will make the recorded sound more harmonious and natural than using the sound of adding artificial sound.